Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Charlestown Homeowners
A broken garage door spring brings the whole system to a stop – the door won’t lift, or it drops hard and won’t stay up. Springs are the most dangerous part of a garage door, and they’re also the part that fails most often. We handle spring work so you don’t have to get near a wound torsion spring or a stretched extension spring. Our technicians have up to 12 years of experience, we service the brands most Charlestown homes actually have, and we can often get to spring repairs the same day you call. Reach us at (866) 401-6449.
What Our Garage Door Spring Repair Service Includes
Not every spring problem is the same, and the fix isn’t either. Here’s what our spring work covers and when each piece comes into play.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a shaft above the door, and it does the lifting work by twisting as the door closes. When it snaps you usually hear a loud bang and the door becomes too heavy to raise by hand. We replace torsion springs with the correct wire size and wind count for your door’s weight, then test the balance before we call the job done.
Extension Spring Replacement
Extension springs run along the horizontal tracks on either side of the door and stretch to counterbalance it. They’re common on older and lighter doors, and they wear at the end loops where the metal fatigues. We replace them in matched pairs so the door stays level, since a new spring paired with a tired one pulls unevenly.
Broken Spring Repair
Most spring calls are for a spring that’s already broken – often a gap in the coil or a door that won’t budge. We confirm the break, check the cables and drums while we’re up there, and replace what failed. If only one spring of a pair has broken, we’ll tell you honestly whether the other is close behind.
Spring Adjustment
Sometimes the spring isn’t broken, just out of balance – the door drifts down on its own or feels heavy going up. Adjustment means setting the tension so the door holds position halfway open. We measure the door’s balance and adjust tension to spec rather than guessing at it.
Safety Cable Installation
Extension springs need a safety cable running through the center so that if the spring ever breaks, the pieces stay contained instead of flying. If your door has extension springs and no cable, that’s a gap worth closing. We install cable rated for the load and route it correctly along the track.
Spring Inspection
A spring can be worn without being broken, and a close inspection catches that before it strands you. We look for gaps in the coil, rust, stretched end loops, and uneven wear between paired springs. An inspection is a quick way to find out whether you’re due for replacement or still have time.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs aren’t generic. The right replacement depends on the door’s weight, the drum and cable setup, and how the original system was built – and that varies by manufacturer. We work on Amarr doors and know how their panel and track geometry affects spring sizing, so the replacement matches the door rather than just fitting the space. We also service Wayne Dalton systems, including their proprietary hardware, where spring work needs care to avoid stressing the surrounding components.
Craftsman and Raynor setups come through our spring calls often too. Craftsman doors and openers are everywhere in residential garages, and we’ve learned where their springs tend to fatigue first. Raynor doors have their own balance characteristics, and we size replacements accordingly. Whether you have Amarr, Wayne Dalton, Craftsman, Raynor, or any other make, we can help – one call covers the door, the spring, and the opener if needed.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sound is usually a torsion spring snapping. The door may still be partly up, but it’s now unsupported and dangerous to move – stop using it and call.
- The door feels extremely heavy. If lifting the door by hand takes real effort, the spring has lost its tension. Forcing it strains the opener and the door panels.
- The door won’t stay halfway open. A balanced door holds position when you let go. If it slams down or drifts, the spring tension is off or the spring is failing.
- A visible gap in the spring coil. A clean break in a torsion spring shows as a gap about an inch wide. Once you see it, the spring is done and the door shouldn’t be operated.
- The opener strains or the door lifts crooked. A tired spring makes the opener work harder than it should, and uneven lifting often points to one spring failing before its pair.
Our Garage Door Spring Repair Process – Step by Step
- 1
We ask what happened on the phone. The sound, whether the door moved at all, and what kind of door you have all help us arrive prepared. It also lets us flag anything unsafe to touch before we get there.
- 2
We inspect the full system, not just the spring. That means the springs, cables, drums, rollers, and the opener’s force settings. A spring failure sometimes damages a cable or a drum, and we’d rather find that now than on a return visit.
- 3
We measure and match the replacement. Spring wire size, inside diameter, and length have to match the door’s weight. We measure rather than eyeball, because an undersized spring wears out fast and an oversized one makes the door hard to close.
- 4
We replace and rebalance. Springs go in, tension gets set, and we test the door’s balance by hand with the opener disconnected. The door should hold at halfway and lift smoothly through the full travel.
- 5
We walk you through what we did. You’ll see the old parts, hear what failed and why, and get a clear picture of anything else worth watching. The price is quoted and agreed before any work starts.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Charlestown?
Garage door spring repair in Charlestown typically runs $180 – $340 for one spring, depending on the spring type, the door’s size and weight, and whether the job is a straightforward replacement or includes adjustment and cable work. That range is for a single spring. Most doors use a matched pair, and pairs are usually replaced together, so a pair costs about twice that range. A torsion spring replacement is the most common call and lands in that range. Extension spring replacement is similar in scope. Safety cable installation and spring inspection sit at the lower end when done on their own.
What moves the price: the number of springs, the door’s weight, whether cables or drums need attention, and access around the door. What doesn’t change it: surprises. The written estimate sets the final price, so you know what you’re paying before we start. Our free estimate covers the inspection, the measurements, and a clear quote – no obligation.
Garage Door Spring Repair Near Charlestown – Our Service Area
We take spring repair calls across Charlestown and the surrounding neighborhoods and cities – the North End, Beacon Hill, East Boston, Somerville, Cambridge, Everett, Chelsea, and Back Bay among them. Getting to you is part of the job, and same-day spring repair is often possible when you call early. If you’re nearby and need garage door spring repair, we can usually work you into the schedule that day. For a wider look at what we handle, see Charlestown Garage Door Repair.
Serving Charlestown, MA – Our Local Coverage Area
We serve Charlestown and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Charlestown
Garage door spring repair is the replacement or adjustment of the springs that counterbalance your door’s weight, so the door lifts easily and stays controlled. It covers torsion springs (mounted above the door) and extension springs (running along the side tracks). Because springs are under high tension, this is a job for a trained technician – we handle them so you don’t have to.
Most single-spring replacements take about an hour, and a matched pair usually takes a bit longer. The time depends on the spring type, door size, and whether related parts like cables need attention. We’ll give you a realistic window when you call.
Typical estimated pricing is $180 – $340 for one spring, with a matched pair running about twice that range. The exact price depends on the spring type, door weight, and any related cable or drum work. Call (866) 401-6449 for an exact quote – estimates are free, and the written estimate sets the final price.
Yes. We work on Craftsman and Raynor doors and openers, along with Amarr, Wayne Dalton, LiftMaster, Chamberlain, Genie, and Clopay. Spring sizing depends on the door’s weight and hardware setup, and we match the replacement to your specific system. If you’re not sure of your brand, we can identify it from the door and opener.
Same-day spring repair is often available when you call early, and a broken spring makes the door unsafe to operate, so it’s worth calling right away. We work fast dispatch from 7am to 7pm. If you need us outside that window, we’ll book you for the next opening – including early mornings or Sundays.
We stand behind our work with a satisfaction guarantee, and we’ll explain what’s covered on your specific job at the estimate. If something isn’t right after the repair, call us and we’ll make it right. Ask about coverage for the parts and labor on your spring replacement when we quote it.
Clear the area around the door and keep vehicles out of the garage if you can, so we have room to work safely. Don’t try to lift the door or remove the spring yourself – a wound spring can release suddenly. Just leave the door as it is and let us take it from there.
Schedule Your Garage Door Spring Repair Service in Charlestown Today
A broken spring is a job to hand off, not wrestle with. Call (866) 401-6449 and we’ll get a technician out, diagnose the spring and the rest of the system, and quote the work before anything starts. Estimates are free, same-day service is often available, and your satisfaction is guaranteed. Whether it’s a snapped torsion spring or a tired extension spring, one call gets it handled.
Written by the team at Charlestown Garage Door Repair.